Ask Experts Questions for FREE Help !
Ask
    wwpirateww's Avatar
    wwpirateww Posts: 6, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2008, 12:25 PM
    93 chevy s10 blazer 4x4 vortec, transmission pan removal?
    Any 1 know how to remove the trans. Pan to change the filter and leaking gasket? It has a cross member going from 1 side of the frame to the tramsmission, the to the other side of the frame , and if it was moved like 1 inch I could get the pan out, but not sure if that's safe
    Any 1 did this before?
    novaman's Avatar
    novaman Posts: 21, Reputation: 4
    New Member
    		  
    #2

    Feb 25, 2008, 05:59 AM
    You are going to have to support the trans. Usually the tail shaft. Then just unbolt and slide back the cross member. It doesn't have to come out.
    Honda_Lady's Avatar
    Honda_Lady Posts: 19, Reputation: 2
    New Member
    		  
    #3

    Aug 13, 2010, 11:22 PM

    When I did this on mine it was a pain and I got soaked in transmission fluid. Like Novaman said you have to support the tail shaft of the transmission. Once you have unbolted it be very careful when sliding the pan out and have a way to tip it the opposite direction from you to drain some of the fluid or you will get soaked in fluid. Luckily I was wearing clothes that could get thrown away when they got soaked.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1992 chevy s10 blazer [ 2 Answers ]

Where is the fuel pressure regulator on a 1992 s10 blazer, mine is running rough and the smell of fuel is very extreme, si suspect the diaphragm has gone bad and raw gas is leaking into the manifold but don't know where to find it.

1996 GMC / Chevy S10 Blazer Steering Wheel Removal [ 2 Answers ]

I need to remove the steering wheel on a 1996 GMC S10 Blazer with tilt. I am already familiar with disabling and removing the air bag, and removing the nut that holds the steering wheel to the column. Chevy has a special puller to remove the wheel. My question is, can I use a generic puller...

2000 Chevy S10 No Heat [ 6 Answers ]

I have a 2000 Chevy S10 Pickup. It is blowing cold air from the heater. I was wondeing if anybody may know why it is blowing cold air.

New chevy vortec 5.7 350 [ 2 Answers ]

I have around 800 miles on my new vortec 350 motor so when I go to power brake and smoke the tires I here the lifters knock or a gas ping noise what could cause this.

Chevy Blazer steering wheel removal [ 1 Answers ]

I would like to know how to remove the factory steering wheel with air bag. For the installation of an aftermarket wheel. Without airbag.

View more questions Search