[Richard Burrows]

How do I reset a kenmore dishwasher when the green light is blinking

[biggsie]

I had the same issue with my kenmore elite-flashing green is error code for heater system.Coil heats water to temp also used to dry dishes. Can be reset by pressing (within 6 seconds)HEATED DRY/NORMAL WASH/HEATED DRY/NORM WASH . All lights will flash. THIS IS PROBABLY A FIRE HAZARD. The dishwasher will restart but quit again next time the heater cycles on. To work on it safely,pull the dishwasher out (should be 2 phillips screws into the counter),and leave open the door.This takes the power out of the circuits,allowing you to safely reach under the very back and find the 2 plastic nuts that hold the heater in place.check the wiring connectors there for heat signs.On mine the wire was burnt right off. If you remove the heater by removing those 2 plasti nuts is easy to replace and costs about $40. I paid $7 for 1 new plastic nut.Look for traces of water on floor below-mine dripped a tiny amount(1/2 teaspoon) and was done like dinner. If you remove it the instructions say to replace it. Look for the servicemans schematic in the paperwork you got with the dishwasher.If wiring looks OK ,Have other issue than element replacement.: