 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Leviton PR180 stopped working after a power failure
I installed a Leviton PR180 a few months back and it has been working great, that is until yesterday. We had a few momentary power outages, and after the second one the switch stopped working. There is power going into the unit, but no green light on the sensor. I checked all the cb's/fuses and gfi's but all were good. Is there an internal fuse on this unit?
|
||||
|
||||
|
There is no serviceable parts inside. There must have been a switching spike of brief high voltage that destroyed an electronic part inside. All you can do is replace the sensor.
If these types of power outages are common, even if their not, whole house surge protection at the main panel may be in order. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hello, I purchased the Leviton PR180 to wire into a 3-way switch installation. My setup is exactly like the wiring diagram in the instructions, but I cannot get the #1 switch (original 3 way switch) to turn the lights on after the motion detector has timed out and turned off the lights. I...
Hi everyone, This is my first question on the forum so here goes... A while back I installed a Leviton PR180 Motion Detector Light Switch in my laundry room and it worked beautifully. Earlier today I installed a 2-bulb fluorescent fixture in place of the incandescent fixture and this is...
I purchased the Leviton PR180 and I would like to know if I can install without the switch. Could you please send to me the diagram? Thanks in advance, Marcelo Tralhao
I am thinking of ventilating 2 separate bathrooms with one attic-mounted Panasonic inline fan. I wanted to install a timer in bathroom A and a timer in bathroom B to control the fan. Unfortunately, there is no such thing as a 3-way timer. The idea of using 2 timers in a parallel circuit crossed...
Newbie here - hopefully you guys can give me some help on a wiring question. I have two boxes - box 1, which is where I would like to put the PR180, has the following wires: Hot, Traveler A and Traveler B. Box 2, which is where the normal 3-way switch is, has Traveler A, Traveler B and what I...
View more questions Search
|
