Ask Experts Questions for FREE Help !
Ask
    jank's Avatar
    jank Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 28, 2008, 03:04 AM
    Leaking non-return valve
    Hi there! We're tearing out our hair here: We've just fitted a non-return valve into the outlet hose between the washing machine and u-bend. This has been secured with jubilee clips. Prior to this, foul water was entering the sink, due to a blockage which has now been cleared. Unfortunately, when we put the washing machine on, thinking the problem had, at last, been cured, we discovered that the connection between the hose and non-return valve is leaking badly. Does anyone have any ideas? Is there a better way of fitting the valve than using jubilee clips?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Jan 28, 2008, 05:41 AM
    A picture here might be worth 1000 words. Use "Go Advanced" to do it.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Jan 28, 2008, 11:51 AM
    If I am following this correctly... go to home improvement store and purchase some stainless steel clamps.. these will allow you to tighten down on hose and valve end more than jubilee clips will... just do not overtighten. Hope this helped!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leaking Shut off Valve-How do I repair it? [ 2 Answers ]

Went to fix a leaking sink in my bathroom. Turn off the water shut off valve in the basement when I went to turn the water back on (fix the leaky sink)the shut off valve will not stop leaking. How do I repair it?:confused:

Leaking valve [ 2 Answers ]

I have a leaking valve under my bathroom seak. Is there an easy way to fix it without turning off the outside water?

Leaking appliance valve [ 1 Answers ]

I recently bought a washing machine which only uses one inlet hose. The one that isn't been used now leaks even though I have turned it off. It is beginning to rot the kitchen cupboard and I fear it may rot the floor boards. Can anyone help?

Safety valve leaking [ 2 Answers ]

I installed new pressure switch and new tank, also new pressure gauge, also replaced the safety valve. Pressure switch is set to kick on at 40 psi and off at 65 psi, safety valve is suppose to open at 75 psi. How ever I get a small amount of leakage from the safety valve. What's my problem?

View more questions Search