Ask Experts Questions for FREE Help !
Ask
    ornursery's Avatar
    ornursery Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 23, 2008, 10:03 PM
    Which high effieciency condensing boilers are best?
    We are seeking a new boiler to boost capacity in our nursery which is heated by hydronic heat. The new boiler would input approx. 200,000 BTU. There are a number of brands available with slightly different equipment and claims. Anyone have experience and opinions as to the effectiveness, quality and reliability of any particular machines?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 23, 2008, 11:05 PM
    For that size unit get the large Munchkin unit. Model Number 199VWH

    Heat Transfer Products, Inc.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hot water Boilers [ 2 Answers ]

Hi I have a weil mclain ultra boiler that keeps going onto soft lock out any ideas as Im getting cold

Gas boilers [ 1 Answers ]

How much is a direct vent gas boiler for residential use (140,000 BTU)? I cannot find any prices on these things on the internet, and I'm getting estimates and I don't know if they have priced them way out of line or not. How can I find out? sharon van buren

HVAC Boilers [ 1 Answers ]

How does a Buderus 315 gas Boiler compare to a Weil McClain Ultra (same size) in terms of efficiency and performance? Thanks

Hardy outside boilers [ 9 Answers ]

I have a hardy Outside wood boiler that I need to wire a new t-sat too and use my my blower on my rheem furnace can someone tell me how to do this also I ran a two wire t-sat wire to the wood boiler for the pump to run but I do not were these wires go. Thanks

New condensing unit problem [ 1 Answers ]

I installed a new condensing unit and put freon in the unit, I am getting the same pressure on the high and low sides of the gauges. This leads me to believe that there is a compressor problem or that I put too much gas in it. I am reading 150 psi on the high side and the gauge is pinned on the low...

View more questions Search