Ask Experts Questions for FREE Help !
Ask
    mike60's Avatar
    mike60 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2008, 11:35 AM
    Heating duct air temp
    Is there an basic or average temperature that the warm air should be that is coming out of the heat vents? It seems that even at it's warmest the temp of the air coming from the vent is only about 74 degrees, which once it moves out of the vent a couple of feet feels cold.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 19, 2008, 12:33 PM
    If you have a heat pump it could run that cool but I believe you are having some other kind of a furnace problem. Have you had your unit serviced lately?
    mike60's Avatar
    mike60 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 19, 2008, 05:56 PM
    This is a brand new unit installed in July. It is a propane furnace
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Jan 19, 2008, 07:00 PM
    You have a problem. Temp way to low for propane if being used to heat 55 to 60 degree return air. Call the company that installed your unit. There should be a one year labor warranty from the installer/seller. If you bought it on the net no warranty for labor and good luck getting parts under warranty.

    You might check your gas pressure.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heating turns itself off before reaching desired temp [ 9 Answers ]

Background: I have an older Trane furnace (manufactured 8/1994) made by American Furnace Inc. (The Trane Company, Trenton, NJ) model TUJ080A936A0. The module controller is by White-Rodgers Emerson Electric Co. Model 50A52-101. There is no gas pilot light. Problem: Recently, my gas valve will...

Heat not kicking on until the temp dips below 64 degrees, target temp set to 72 [ 2 Answers ]

Hello, This is my first time posting here, but I figured it was a good place to start for some advice. I just bought a new townhouse a few weeks ago and have been having some heating issues since moving in. The actual furnace (Goodman GMS 8045) was installed in June of '06 while the unit was...

Heating unit not reaching room temp [ 1 Answers ]

My heating unit doesn't generate enough heat. Everything comes on but stops running before reaching room temperature. I've turned on and off the wall-thermostat and it works. Is this a sign that the wall-thermostat is going bad or went bad on me?

Temp gauge showing temp, 2001 Chev Malibu [ 13 Answers ]

I have a 2001 Chev Malibu LS, V6, temp gauge is not showing any heat at all, not registering when I know the coolant is hot ? Veh has about 126000 mi on it, never been flushed out, thought I would attempt to flush myself but don't you think the problem might be a bad thermostat ? If so, where and...

Flexi Duct vrs Aluminum Duct [ 4 Answers ]

I am adding an addition onto my house. The local building inspector has already told me my HVAC unit is more than adequate in size to support the addition. The old duct vents are aluminum. Can or should I use flexi venting in the new part? What are the pros and cons of these two types of vent...

View more questions Search