Ask Experts Questions for FREE Help !
Ask
    henry swift's Avatar
    henry swift Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2008, 01:44 PM
    Using johnson control on honeywell gas valve
    I have a new honeywell gas valve for my furnace M# VR8345M 4302.
    I am trying to use a Johnson Ignition Control G770 MGC-3 to operate
    This valve.
    The problem is I want to use the intermittent function of this honeywell valve
    And the johnson igniter control has no provision for the mv/pv on the igniter.
    Is there an alternative way to wire this control?

    Thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 16, 2008, 03:39 PM
    While it can be done I never recommend mixing different manufactures components especially in areas of gas control, ignition and safety.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Control valve will fire up but will turn off in a few seconds [ 2 Answers ]

I have a heater on my garage and it will fire up but it turns off in a few seconds does that mean that my control valve is bad

Evaporative Emission Control System Purge Control Valve circuit Malfunction [ 3 Answers ]

p0443 Evaporative Emission Control System Purge Control Valve circuit Malfunction on mazda melinia s 1996 83k?what is the next stip? I cleared the check engine light and it went off ,and after 60miles driving it cames back again?why and how can I fix it ? Also what is the cheapest way to reset...

Do I have a faulty Honeywell valve V8043E1012 ? [ 2 Answers ]

I have 3 zones with 2 circulators. One circulator serves 2 Honeywell V8043E1012 valves. One valve serves the second floor of my home and may not be working correctly because there seems to be very poor hot water flow through the baseboards (it's cold!). I suspect the valve's power head may be...

Honeywell Smart Valve failure [ 2 Answers ]

I have a Tempstar furnace and what is happening is the furnace will call for heat and the draft inducer motor will come on and after a momont I will hear the pressure switch go and nothing happens. The electric glow rod does not glow and the furnace does not fire but here is the catch the first...

Purge control Valve [ 1 Answers ]

I have a 1998 nissan Altima and I'm trying to located where it is because I went to a mechanic yesterday and He didn't know where it was. I'm trying to do it myself. If anybody knows I need some help thanks

View more questions Search