Ask Experts Questions for FREE Help !
Ask
    qiaocao28's Avatar
    qiaocao28 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 1, 2008, 05:14 PM
    Frequent turn on and off at start of program for noma thermostat
    I turned my cycle rate to cr-0 so it would stop turning on and off and operate in a +- 0.5 degrees, which is fine for me

    However what seems to be occurring is that at the beginning of my preset program, it frequently turns on and off before reaching the set temperature. I'm trying to get it to just turn on until the set temperature and then turn on and off every +- 0.5 degrees

    Any help is appreciated
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Jan 2, 2008, 02:24 PM
    Are you shure this is a thermostat problem. Furnace could be turning of and on because a limit is opening do to poor airflow, dirty filter etc.
    qiaocao28's Avatar
    qiaocao28 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 2, 2008, 07:35 PM
    I don't think it's a furnace problem
    Before when I just had the mercury kind with the little temperature dial, and it would just run
    Plus once it reaches the set temperature, it will go up to 0.5 above the temperature, drop down 0.5 below the temperature and then rise back up
    therinnaiguy's Avatar
    therinnaiguy Posts: 153, Reputation: 5
    Junior Member
    		  
    #4

    Jan 3, 2008, 07:23 AM
    Good ole' Canadian Tire cheap stuff!
    therinnaiguy's Avatar
    therinnaiguy Posts: 153, Reputation: 5
    Junior Member
    		  
    #5

    Jan 3, 2008, 07:27 AM
    Try this link. UPM Marketing Inc. -Programmable Thermostats
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I program NOMA photocell timer for dusk to dawn> [ 1 Answers ]

Hello, I bought the single button timer for outdoors that can be set up for specific hours (up to 9) or on at dusk and off at dawn. I've lost the instructions. Can you help me? Thank you Sheryl

Program a noma et420c outdoor timer [ 2 Answers ]

I lost the manual to my outdoor timer, NOMA ET420C. I think it's more complex than the one mentioned elsewhere on this site. How can I program it (or obtain a manual).

Noma thermostat 52-2558-8 can't turn on hear [ 5 Answers ]

Noma 52-2558-8 programmable thermostat -------------------------------------------------------------------------------- I have just installed this new thermostat to replace an old non programmable one. I have a gas furnace, no air conditioning, my old thermostat have five wires Red, Green...

Program noma themostat [ 1 Answers ]

Purchased a new home with a noma programmable thermostat no instructions were left at the house. How do you program the air conditioning.

View more questions Search