Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Installing noma digital thermostat
 [ 4 Answers ]
 Hi - I am having difficulty replacing my old thermostat with a Noma brand programmable thermostat. The old thermostat - an old manual mercury type - is connected to 5 wires labelled on the circuit board as G, R, Y, W, and 4. it looks very much like the model shown on this website: ... 
Noma Programmable thermostat
 [ 14 Answers ]
 I have tried to replace a conventional lever action mercury thermostat with a new digital programmable Noma thermostat. The AC works fine but when I turn on the heat, the AC come on then too and not the heat. I have no heat. This was the wiring for the original thermostat: Orange -> Y Red ->... 
Do I need a new Thermostat?
 [ 1 Answers ]
 :( Here’s my problem: I have a basic thermostat. It's the one that has the needle on the right side. I set it to 78 deg. And my AC unit will not turn off until it reaches 74 deg.'s:confused: Then when the temperature gets to 76 deg.'s my AC starts back up again! :eek: (hence with out the... 
Noma Thermostat
 [ 1 Answers ]
 I have installed two Noma non-programmable thermostats in my bedroom. On controls the heat and the other controls the AC. My question is, why are the displayed temperatures different on each thermostat? They are literally 2 inches apart and the indicated temp on one is 1.2 degrees higher than on... 
Help with new thermostat
 [ 1 Answers ]
 
I have been having some issues with the heater lately. First off I have a heat pump with backup gas furnace, and a/c. It seems that the fan continually runs. It also seems that the heat pump never runs even though I have the thermostat set to “heat” not “emer heat”. Also the fan seems to run... View more questions Search 
  |