[coldtrain]

I am building a bathroom with two tolets from scracth and two sinks have no ideal where to start.:) :)

[speedball1]

You must first locate the main. Most bathroom groups are roughed in like this.
Toilet connects to sewer main or the stack vent. Lavatory connects to the two toilet drain and runs a vent off the top the stubout tee out the roof or revents back into a dry vent in the attic.. The toilets wet vents through the lavatory vent and the tub/shower connects to the lavatory drain and is wet vented by it. This is a normal rough in and is acceptable both by local and state codes and also The Standard Plumbing Code Book in 90 percent of the country. Check your local codes.to make sure you're not in the excluded 10 percent.. The vent off the lavatory may be run out the roof or revented back into a dry vent in the attic or if you're reventing back into a fixtures dry vent you must make your connection at least 6 inches over that fixtures flood rim. Good luck, Tom