Ask Experts Questions for FREE Help !
Ask
    ybull's Avatar
    ybull Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 13, 2007, 09:00 PM
    Frigedaire Terminal Limiter
    I think I need to change this part and have found it on my dryer. My question and concerns are... I have replaced the timer switch, which is what started this all. I think I may have blown a fuse within the dryer... would it be the Terminal Limiter? I don't want to run out and spend more money on this if I need to be checking on something else. After replacing the timer it gave out a loud buzz and then would not turn on. Replaced the timer because it would not advance while drying on any setting. Can someone give me any clues :)
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Nov 14, 2007, 12:25 AM
    Check the thermal limiter for continuity.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermal limiter switch for Frigidaire dryer [ 1 Answers ]

How do I access the thermal limiter switch on a Frigidaire model#FDEB23RGS1? I can't find it. What does it look like? I really would appreciate your help.

Health insurance won't pay for terminal diseases [ 2 Answers ]

Where i work, the insurance is very strict... If i slip, fall and break a leg, insurance won't pay for medical services if I was the one to spread water on the floor so we have to be extra careful but when i read the policies very carefully... i saw a clause that no one in my office seems to have...

Furnace-Yellow terminal not connected-A/C starts stops [ 3 Answers ]

I have a 1988 Rheem RGDA-125-ER furnace. I noticed over the summer that the A/C, when switched to cool, would come on and then immediately switch off if the set temp was higher than the room temp. If I programmed the set temp far below room temp and then switched on, it would run normally and I...

No RC terminal on new thermostat? [ 8 Answers ]

Hello: I saw your name on an internet search for thermostat wiring problems, so I thought I would try you for this one. I could not get help elsewhere. I have an oil burner, and a separate a/c unit. I installed a programmable thermostat 2 years ago that works well, although the location is...

Powering the G terminal on my furnace control board [ 1 Answers ]

Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am...


View more questions Search