Check out some similar questions!

KathyNeedsHelp · Nov 6, 2007, 02:16 PM

During the "Add a garment/Wash" cycle I'm getting an F followed by an H (or reverse) code. No numbers, just "F" and "H". The washer will not move past this till I pause it then restart it and it usually goes away. Today I had to do this twice to clear the code. This has happened 3 times over the last two weeks (I do at least 7 - 10 loads a week) - any help would be appreciated. I've lost my manuals somewhere and have no idea what's going on here.

applsvcgirl · Nov 7, 2007, 06:24 AM

FH code is no water detected entering the machine or Pressure switch trip is not detected. Here is a complete manual for your unit
RapidShare: 1-Click Webhosting

KathyNeedsHelp · Nov 7, 2007, 12:35 PM

Thank you so much for your help applsvcgirl! I did not know Whirlpool made Kenmore parts for washers - the document is most appreciated! I will follow the recommended diagnostics to find out why I'm getting this error code. Again, Thank You!

applsvcgirl · Nov 7, 2007, 06:30 PM

No problem! Better to have it and not need it then need it and not have it. Good Luck!