Ask Experts Questions for FREE Help !
Ask
    jlcook's Avatar
    jlcook Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 30, 2007, 08:39 AM
    Goodman Gas Furnace Not Working
    I have a Goodman Model # EG030075-1AB REVC Gas Heater it has been converted to run on LP Gas. Furnace has worked fine for years. Turned the heat on and nothing happens. The LED on the control board is not lit. I checked the voltage at the control board and all the voltages appear to be normal. The voltage to the gas control valve seems to be off though. I thought the valve was supposed to be supplied with 24v from the control module but it is only reading approx 4v when checked. There is no gas flow no fan no nothing happening with this unit. Where do I go from here?
    hixton's Avatar
    hixton Posts: 146, Reputation: 5
    Junior Member
    		  
    #2

    Nov 2, 2007, 08:43 PM
    Check to see if the rollout switch it tripped its in front usually between the valve and the burners just above the burners
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Nov 2, 2007, 09:09 PM
    If the LED isn't on, you likely have control power problems or perhaps a bad board. Where did you check the control voltage? Do you have 24 volts AC between the R and com terminals? If not, check the fuse on the board.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Gas Furnace [ 3 Answers ]

I have a Goodman Gas Furnace, the hot surface ignite will not come on nor the flame sensor. I have tried everything and I am fresh out of ideas. Could you please help me on this. Thanks

Goodman gas furnace [ 3 Answers ]

I have a problem with the heat. I replaced the circuit board & pressure switch. It still flashes 3 times saying pressure switch. Heat does not come on

Goodman gas furnace [ 1 Answers ]

I have a newly installed Goodman gas furnace.It's 93%efficiency natural gas ,forced air,model #capf3o30b6ah Does not blow out very warm air , is this normal.

Goodman Gas Furnace [ 1 Answers ]

Up until yesterday my furnace was working fine now it does not come on at all. I have turned off the power to it and the breaker and still nothing. I also have tried turning on the air and that does not come on either. I don't know the model number but I have been using it for about 4 years now.

Goodman gas furnace [ 3 Answers ]

I have a goodman gas furnace, gms91155dxa for about a year. Recently I notice the furnace repeats on and off while it didn't reach at set temperature. After the heater is on, it runs some minutes and it shuts off itself. And the draft inducing motor runs, the ignitor is on and gas blows and in...

View more questions Search