Ask Experts Questions for FREE Help !
Ask
    Jaamay's Avatar
    Jaamay Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 29, 2007, 12:37 PM
    Blower on, no heat, thermostat off
    Hi

    I have a Tempstar 7000 NUGK0175DG09 about 14 years old, split system gas furnace / AC

    I turned the furnace on for first time - everything seemed fine and had heat

    Heat then turned off, and blower continued to run. Tried replacing thermostat to no avail.

    Now, even if thermostat switch is off (with either old or new thermostat) blower runs constantly and never get heat. I have to either turn breaker off or remove lower panel to stop blower

    Any help / ideas would be greatly appreciated
    juggallojed's Avatar
    juggallojed Posts: 165, Reputation: 10
    Junior Member
    		  
    #2

    Oct 29, 2007, 06:01 PM
    Seems a safety might be open and that control board will keep the fan on.at least until you reset the power.

    Read the faq section for the answer.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to Wire a Thermostat to blower fan for alternate heat source [ 5 Answers ]

Hello all I just built a plenum around my coal stove and I need to wire in a stat , limit switch to run a blower fan . Thanks Steve PS I have all the parts off and hot air oil furnace.

Furnace blower on - no Heat [ 20 Answers ]

I have a Carrier furnace with an automatic ignition. The fan is constantly running but it is not heating. Additional Information: Model 58PAV: The Red Led Status light is rapidly flashing - which according to the manual means 'Line voltage (115VAC) polarity reversed. If twinned, refer to...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

No heat but blower still on [ 3 Answers ]

All of a sudden I have no heat. I have a programmable Simple Comfort 3001 thermostat and haven't had any issue with it for 1.5 years. Forced Hot Air Heat / Gas - what could be wrong ? My furnace has no pilot light - its only 2 yrs old. Help !

Blower on, no heat [ 1 Answers ]

I have a tempstar NTC6 125KJGI. I turned it off at the kill switch attached to furnace the other day to clean the filter. After cleaning the filter it now blows cold air. However, I think I see the gas igniting when it kicks on. Blew hot air before. 2 months ago an inspector said it was in...

View more questions Search