Ask Experts Questions for FREE Help !
Ask
    danzgrl's Avatar
    danzgrl Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 28, 2007, 12:16 PM
    Plumbing Vent
    Does anyone know how I can get my plumbing tube vent through a 2x4? Thanks in advance.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Oct 28, 2007, 02:00 PM
    How large is your vent stack? Is the 2x4 load bearing or just a wall stud?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Plumbing Vent [ 3 Answers ]

1)Combination waste and vent has a vent pipe which runs horizontal for 15ft and than rise up through roof. UPC does not have any paragraphs to object this. Does anybody know what the risks are. THis is a system serving to one floor sink only with 2" tail pipe and 3" waste line.

Moving plumbing vent [ 5 Answers ]

I am in the middle of remodeling my bathroom which includes taking out a wall. The wall has the plumbing vent running up through it. I just need to move the vent less than 6 inches to run up through the outside wall to the attic. It looks easy enough, but is it OK to put two bends in the vent pipe...

Plumbing vent to roof [ 1 Answers ]

While trying to run a snake down the roof vent, the darn thing came completely out of the spindle and the snake fell down the vent. Now I have 14' of snake down the darn vent and can't see the free end. Is there some obvious tool I can find or rent that will allow me to fish the thing out? ...

Drain/Vent Plumbing [ 4 Answers ]

I actually have two questions. I'm adding a bar sink drain to an existing laundry sink drain. The drain from the laundry sink is 1-1/2" PVC, and this goes to a sanitary double wye with 2" PVC going into the floor, and 1-1/2" PVC going up to a vent. I replaced a single sanitary wye fitting with...

View more questions Search