Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring Aprilaire 700 Humidifier
[ 6 Answers ]
I am installing a Aprilaire 700 Humidifier on a Goodman GMNT gas furnace the Furnace control board is a white rogers 50T 35-730 it has separate hum 24v Terminal and hum 120v terminal the Aprilaire 700 Humidifier includes a built in 110v to 24v transformer which one should I connect it to and also...
Humidifier and high efficiency furnace
[ 2 Answers ]
I have 7 years old high efficiency furnace and new flow through humidifier. Problem is that I do not have necessary level of humidity in my house. It is never more then 26%, which is dry. Should be between 40-60%. Everything works fine, water flows through humidifier every time furnace...
Aprilaire Communicating Thermostat vs Lennox GHR32V Furnace
[ 8 Answers ]
Lennox furnace doesn't work after changing out thermostat to an Aprilaire model 8870 communicating thermostat. Have triple checked the most obvious and wiring at both ends. Furnace powers up but will not ignite. Have changed out the new Aprilaire for another exact model. Still no luck! ...
Humidifier dumps water out of furnace
[ 6 Answers ]
I woke up three nights ago to the furnace blowing cold air. I have this problem once per year and I have to clean the flame sensor. This time though, I found a lot of water on the basement floor by the furnace. I cleaned the flame sensor and the furnace worked fine for about 4 hours then went...
Aprilaire Humidifier
[ 1 Answers ]
I just installed an Aprilaire 550 humidifier on my Goodman furnace but can't figure out how to wire it. The furnace has a control board which has a 24 volt HUM terminal. My humistat has two terminals. I am looking for a very simple explanation on how to wire this thing up. View more questions Search
|