Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have AC, but no heat... Is the problem my furnace?
[ 7 Answers ]
At first, my motor fan would cut off. After replacing the fuses, it kicked back on and I had cool AC. Later down the line, I noticed frost on the pip leading from the furnace to the motor fan. I purchased some insulating tape and called it a day. It seemed to keep it from freezing. Now, I tried...
Heat Pump? A/C? New Furnace
[ 9 Answers ]
A/C died over the weekend. Repair guy checked the system and found "the compressor seemed to be drawing high AMPs". Replaced a blown fuse and then quoted me $4800 for a whole new system. Quoted Armana Distinctions 70,000 BTU 95% furnace, 2.5 ton 13 seer condenser, coil and pump. Figured that I...
Heat/furnace won't cycle
[ 1 Answers ]
Hi, I have a Central A/C & Heat Unit on my roof, it is about 18 years old. The A/C works fine. I have a prof replace the ignitor last year and it gets a little better. However, I noticed that the heat still have problem whenever it started continually running for more than 20 or 30 minutes, then...
Furnace has no heat
[ 3 Answers ]
Please help My furnace is not working and I know very little about it.. I was told it does not have pilot but has an ignitor... I turned it on yesterday but it didn't come on.. There is a glass mirror on the door that has a red light in it.. The red light brinks rapidly so I know it has power...
Furnace won't heat in Auto
[ 2 Answers ]
I have read the different posting and replys, but they don't seem to address my problem. Friend has an older Kenmore Power Miser 70 that has an old electronic ign. (no flame senser). The furnace will heat when the fan switch is set to "on" position, and it will cycle the heat. When the fan is... View more questions Search
|