Ask Experts Questions for FREE Help !
Ask
    KimberlyW's Avatar
    KimberlyW Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 25, 2007, 05:40 PM
    Starting a Bryant 310aav
    I am attempting to start my furnace for the first time since last winter. My furnace is a year old Bryant 310aav which I understand doesn't have a pilot light. I have "reset" the furnace as suggested by an online trouble shooting method by turning off the unit on the side but I have had no luck getting the furnace to turn on. I have also tried turning off all the breakers. Help! It is supposed to be 36 tonight!!
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 25, 2007, 06:00 PM
    you have a window on the bottom door of the furnace count the blinking light it will tell us what's wrong. (two flash pause one flash = code 21 ) You should have a code sheet on the door to tell you what each code is. With out the code its hard to say what's wrong the system should be under warranty. Let us know if you get a code.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 310AAV code 23 [ 8 Answers ]

I found your forum after having some issues with my furnace. Age is unknown because I rent and my landlords are out of town. When I went to turn the furnace on tonight, nothing happened. House temp registering 68-69 at thermostat, furnace doesn't kick on when adjusted to 72. Fan will turn...

Bryant furnace does not come on [ 3 Answers ]

We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house. When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners...

Bryant gas heater model beginning 310aav [ 3 Answers ]

I had not used my furnace over the summer. Before turning on the thermostat, I replaced the filter and checked to make sure red light was on solid. Turned on thermostat and furnace light started blinking error code 23, which according to list on furnace means pressure switch obstructed or off. I...

Gas furnace blowing cold air (Bryant 310AAV) [ 5 Answers ]

Folks, Could really use some help/advice. I have a Bryant 310AAV gas furnace installed in our home. This is new construction (4 years old) so I assume it's one of the new furnaces that does NOT have a pilot. Here is the problem: The furnace is not blowing any hot air. I've turned the...

Bryant Burner [ 3 Answers ]

I have a valve on a Bryant Burner for an old gas furnace. There seems to be a problem with the gas valve that feeds the burner. Are 40 year old valves available? Thank you. Dennis

View more questions Search