Ask Experts Questions for FREE Help !
Ask
    perickson's Avatar
    perickson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 13, 2007, 08:15 AM
    Bathroom fan
    I recently had a bathroom ceiling fan installed but I can't tell if it is working properly. After showering the mirror, windows and walls have condensation. Is there a way to test the fan to see if it is working properly?
    ebaines's Avatar
    ebaines Posts: 12,131, Reputation: 1307
    Expert
    		  
    #2

    Oct 13, 2007, 09:18 AM
    Turn the fan on, then get up on a chair or ladder and hold a piece of toilet paper up near the fan, and see if the paper is sucked upward against the grill. A bathroom fan generally can't prevent all condensation, but it should cut down on it and you should notice an improvement in the amount of "steaminess" in the room after your shower.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #3

    Oct 13, 2007, 11:51 AM
    I've had very good luck installing a 15 minute DELAY-ON-BREAK timer on the fan This causes the exhaust an to run for 15 minutes after it's shut off. It has dramatically cut back on condensation.

    Another, low tech method that was used in the bathroom was to lower the ceiling above the tub/shower area. There is now less of a chimney that will move the steam into the room.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Oct 13, 2007, 12:27 PM
    Nutone/Broan make a VERY Quiet Bath Fan(.3 Sones), with humidity sensor, fully automatic, or manual operation.
    shader's Avatar
    shader Posts: 235, Reputation: 12
    Full Member
    		  
    #5

    Oct 13, 2007, 12:54 PM
    THe fan may be working, but not efficiently. The CFM (amount of air moved) of the fan has to be sized to the bathroom-other factors include the type of vent pipe-solid or flex- length of vent pipe, and number of bends.

    This site has some good info-click on bathroom fan sizing link EFI's Consumer Division Residential Catalogue | Bathroom Exhaust Fans

    THe general rule is to determine the proper fan size, then move to the next size up to insure adequate ventilation. THe fan should run for a minimum of 15 minutes after shower use to insure removal of steam/moisture.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bathroom exhaust fan [ 5 Answers ]

I just replaced the bathroom exhaust fan motor assembly which is the fan motor, squirrel cage, and mounting plate. I did this because the fan is about 25 years old. The bathroom is only 36 square feet with 8 foot ceiling and the new fan motor is rated at 100 cfm. The thing is that the fan does not...

Exhaust fan in bathroom [ 1 Answers ]

I am wiring a new bath and would like to know if code requires an Exhaust fan in bathroom.

Bathroom fan - no duct? [ 5 Answers ]

I wanted to see why the smell in the bathroom was not going away, and I opened the fan grille and noticed that the bathroom fan has no duct. Inside the grille is just a small box with a fan blowing upwards into it, but there is no way for the smell to escape by means of a tube to the roof. ...

Bathroom extractor fan [ 3 Answers ]

Hi I want to replace a timer extractor fan with one that switches on and off with light pull. Having taken off the old one I have been left with 3 core and earth cable and extra insulated extra core cable. The new fan however only needs a neutral and live connection. I connected together the...

Bathroom fan/heater [ 1 Answers ]

I have a dedicated 20 amp circuit going to a bathroom. I want to install a bulb heater and a ventilation fan on the circuit. Can I use a decora combo 15 amp double switch to control both the light and the fan? Or do I need a 20 amp switch?

View more questions Search