Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
200amp service supply line
[ 5 Answers ]
OK here we go I have property up state with no power, the nearest pole is appx 1800ft+ away from where I am going to put a summer house the electric company states it will cost me $25000.00 for poles labour and parts. This is insane. My question is if they put a pole with power on the edge of...
Fittings for LP Supply Line
[ 1 Answers ]
I am trying to make a custom length of LP Gas supply line that has a swivel FPT fitting on each end. At first I was considering using vinyl hose, however I could not find any rated for vapor at the local hardware stores. Also, I'm not confident in adding fittings to the hose ends and preventing...
Leaky lead supply line
[ 11 Answers ]
I found a leak in our building from an old lead supply line that runs underneath the floor. The floor boards come up right where the leak is - so I could get at it and got a good look and the lead pipe had been crimped to seal it. (the pipe was cut off and crimped)The pipe was leaking pretty...
Line Voltage Flexible Trach Kit
[ 3 Answers ]
I installed the track as instructed. I attached a couple of the fixtures, but they would not light. I do have electricity around the track, checking with a voltage detector, but the lights do not light. What could the problem be? Thank you.
Supply line size
[ 2 Answers ]
http://home.comcast.net/~lpeery1/images/plumbing.jpg I need to run supply lines for a bar sink, toilet, bath sink all sharing the same wall (3 colds, 2 hots). Should the two horizontal supply lines I bring over off the main 3/4 inch lines be 1/2 inch or 3/4. Thanks, Larry View more questions Search
|