 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Originally Posted by bsldave
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I am getting ready to attempt this for first time with a Kohler/Sterling unit. It does not mention the use of a mud base. Is this needed? Any earlier post here talks about using a rubber material to prevent squeaks. Is green board the type of material to finish the top areas. The...
Hello, We have a 2 piece shower unit with a gap between the wall and the tub. Should I use silicone to fill this gap? The gap is 1/16 to 3/16 of an inch and water goes in and lays in the back of it. We have trouble cleaning this gap. I have not used silicone because I am afraid mold or mildew will...
I am in the process of installing a bathroom in my new garage addition, and am seeking input for the 36" Sterling shower enclosure. 1) Instruction state that back and side walls can be attached to bare studs or over water resistant wall board. Any opinions on which is best? 2) The base I plan to...
"Do they make a drain receptor with female threads on the inside that could be glued to the 2" pipe afer the base is set, and with the drain grate screwing into that?" They do but I'm not too sure you can use it on a manufactured shower base. It's called a "flange type shower drain", (see image)...
I have a one piece shower that is leaking. I have taken the quarter round off around the front of the shower unit and the adjacent base boards and water is slowly seeping out from under the shower. The quarter round trim was very wet. Is there anyway to get the remaining water out from under the...
View more questions Search
|
