Ask Experts Questions for FREE Help !
Ask
    richlind01's Avatar
    richlind01 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 23, 2007, 11:43 AM
    Troy built mdl.14av809h063
    Troy Built mower mdl.#14av809h063, cannot get drive belt off engine pulley,frame tabs prevent removing belt. How do you replace belt?
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Sep 23, 2007, 03:28 PM
    Well you can remove the center bolt that holds on the pulley and allow the pulley to slip down a little, or you can take a large, long punch and a hammer and carefully tap on the tab to get the clearance needed, you only have to do this on one side, not all three tabs, then work the belt off, then put the new belt on. Then bend the belt guard back into place. If the pulley will slip down a little, that is best.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Repair troy built [ 1 Answers ]

Troy built model 556- lost ability to engage self propelled feature. The cable is fine I took apart the housing attached to the handle and need to close it up . Are there any diagrams that will show me the correct way to place the line within the housing

Troy Built Horse [ 1 Answers ]

Blade engage goes off after 3or4 seconds. I must turn off and start again, 3or4 seconds goes off again.

Troy built fuses [ 1 Answers ]

I think I need to change the fuses on my troy built mower/tractor. How do I check to see if they need to be changed? How do I change them? How do I know what fuses to buy?

View more questions Search