Ask Experts Questions for FREE Help !
Ask
    dpaiac9's Avatar
    dpaiac9 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 2, 2005, 07:21 AM
    Low water pressure
    :( Gas and Electricity Utility company installed a new meter outside our garage replacing the one that existed inside the garage. For no apparently logical explanation water pressure in my house has dropped significantly. Hot water is simply not enough for one person to take shower.

    My house is 45 years old and I purchased it in 1992. Water pressure remained fantastic until yesterday. My 4 children before three of them moved out few years ago, and myself will take hot shower without complaining the quality and the quantity of the water every morning.

    After the meter install, the utility service man went to see the furnace located in the basement. The water heater and the main water shutoff valve is also located there. I don't have no clue what he did with all those gadgets but he wanted us to turn off the heat and after a while told us to turn the heat back on before leaving our premises. What could possibly be the reason for the pressure drop. I would appreciate your help very much. I checked the shut off valve and found it fully open. Thanks.
    Sincer
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Dec 2, 2005, 04:21 PM
    "Gas and Electricity Utility company installed a new meter outside our garage replacing the one that existed inside the garage. For no apparently logical explanation water pressure in my house has dropped significantly."

    The Power Company installed a new electric/gas meter and now you have no water pressure?

    The only explanation I can come up with is that in doing so they disturbed some mineral build up on the pipe walls and now it's clogging your system. Have you checked a few aerators to see if the screens are clogged? If this were my call the first thing I would do is shut the water off at the meter and open up the4 house shut off. Then I'd turn the water back on for a few seconds and have someone check to see if there was a full stream. If not I would flush out the service line. If I had a strong stream then I would track the loss down from one fixture to the next. Somewhere along the way I'm going to run into a pressure drop. That's where I'd find the clog. You may need to bite the bullet and call in outside help to get your pressure back. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water tank height versus water pressure [ 3 Answers ]

I'm not a physicist so I need your help. I live in Mexico. We have a water tank sitting on the roof - there is no pressure pump. The water pressure in the house is very low. Is there a rule of thumb (for the common man) that will tell me how how much pressure increase will result from raising...

Increase Hot Water Pressure w/Water pump? [ 3 Answers ]

Would a Watts Premier Hot Water Recirculation Pump (http://www.costco.com/Browse/Product.aspx?prodid=11026121&whse=BC&topnav=&cat=&s=1) (or any other brand name) help to increase hot water pressure if you install it directly to the hot water output pipe and then turn it on ONLY while taking a...

Low water pressure [ 1 Answers ]

I have a well and I am losing pressure off and on during the day. I have a water softener but it is not charging at the time of the low pressure. It occurs throughout the house not just one sink or bathroom. What could my problem be?

Water pressure/water softener? [ 1 Answers ]

I have a "waterfall" faucet in my tub (separate shower). I turned on the water to the tub the other day and it barely runs. Then tonight my daughter was running the tub faucet and I had no hot water pressure to the kitchen. This has never been a problem. I understand from reading that we may...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...


View more questions Search