Ask Experts Questions for FREE Help !
Ask
    paws's Avatar
    paws Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 5, 2007, 09:42 AM
    Universal tub spout
    I am trying to replace my tub spout with a universal tub spout and I cannot get the old one loose, any idea's?
    JohnSnownw's Avatar
    JohnSnownw Posts: 322, Reputation: 51
    Full Member
     
    #2

    Sep 5, 2007, 09:44 AM
    Try using a large monkey wrench, for more leverage. It should simply twist off. It's probably stiff due to the teflon plumbers tape around the threads.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #3

    Sep 5, 2007, 12:17 PM
    If it had teflon tape on it, you would likely have it off already. More likely it is pipe dope, crud, rust, and corrosion. A bigger wrench can lead to chopping a hole in the wall to repair what you twisted off. Heating it with a torch and quenching should work. If you don't have a torch, try hammering on it. If you can get at the joint, a little penetrating oil may help. I like spray silicone. The hammering will break up the crystals of oxide locking it in place. Spray, hammer, twist, curse, spray...
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #4

    Sep 5, 2007, 12:21 PM
    Are you sure this spout is screwed on and not a slip on with a set screw? Check on the underside for a possible set screw, if it is there back it out and then pull straight out on the spout with a slight twist. If there is no screw then try Labman's heat/cold approach.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bath tub spout [ 23 Answers ]

I replaced my bath faucet and now am struggling (to say the least) to get the tub spout to not leak. It is a brand new spout that come with the faucet. A delta faucet. I cannot get the spout to not leak. I did the directions to a T and for whatever reason the spout keeps leaking through the...

Tub spout [ 2 Answers ]

I have a tub spout with a diverter the diverter has to remain up or else I will leak down my basement. Now it leaks every time after a shower. Help

Tub spout [ 2 Answers ]

Can a spout with a pop-up knob be used to replace a normal spout that didn't have a pop-up from the beginning ?

Tub Spout [ 3 Answers ]

I have an old tub spout with diverter that I am trying to replace. The pipe underneath has a 1 1/4" adapter attached that has been in place for 10 years. My question is how do I remove that adapter? I know heating it is an option, but what should I use that won't melt the plastic tub wall, and how...

Tub spout dripping [ 5 Answers ]

My bath tup spout/faucet is dripping. What can I do about this? Thank You


View more questions Search