Ask Experts Questions for FREE Help !
Ask
    sacramento's Avatar
    sacramento Posts: 163, Reputation: 1
    Junior Member
    		  
    #1

    Aug 30, 2007, 08:38 PM
    insufficient dryer heat
    Hi, everybody = been moving house and home and simply have not had time to visit with you! Which brings me to my need for help: I have a Frigidaire stacked washer and dryer. In the moving, the hinge on the dryer door got bent but my husband straightened it out. Now, however, the dryer needs two or three cycles before it really gets hot? What to do? Thanks for your help!:confused:
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Aug 31, 2007, 04:52 AM
    The hinge that got benton the door is not letting the door seal properly. More than likely you will have to replace the hingeor door( if it is bent as well) to get it to seal tightly
    sacramento's Avatar
    sacramento Posts: 163, Reputation: 1
    Junior Member
    		  
    #3

    Aug 31, 2007, 07:27 AM
    Apparently I can't rate you but I want to thank you so much! You just confirmed what I have been saying and my husband has been denying! Thank you again.:)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer won't heat up [ 3 Answers ]

Our gas dryer has suddenly stopped heating up when I turn it on. Everything seems OK but there is no heat an dno drying going on. Any ideas?

Dryer without heat [ 3 Answers ]

I have a Kenmore dryer, which I used yesterday to do some laundry, and it worked fine. This morning I wake up to finish the laundry. And the dryer is not heating up at all. It turns on and spins the clothes, but its been on for over an hour and everything inside is cold and wet. The model # is...

Dryer does not have any heat [ 7 Answers ]

What happens when my dryer has no heat?

Dryer won't heat [ 2 Answers ]

We have replaced all heating elements, fuses, thermostats, etc... We have checked all wiring with the relay switch and still only blows cold air. We have the Kenmore 80 series. Can someone please help us?:(

Insufficient heat being produced by gas furnace [ 4 Answers ]

I have a gas furnace, located in the attic, and very warm air blows from a few vents in the ceiling and coolish air comes from other vents in the ceiling. I do not know what could be causing this problem. Please help. Judd

View more questions Search