Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Removing lead and oakum seal properly
[ 1 Answers ]
Underneath my washing machine I ran into a unusual drain configuration. The machine drains into a threaded 2" od pipe that runs into a cast iron bowl, about 12" diameter, but the pipe threads into the center of the bowl, so there is no overflow and if there were there is no way for it to get out. ...
Seal or don't seal new grout
[ 1 Answers ]
I am remodeling my bathrooms. Should I seal the grout? My contractor says no. What are the pros and cons of each decision?
Removing faucet handle after removing screw on top
[ 7 Answers ]
My hot water is leaking.. I remove the top screw on the handle; the handle won`t come off.. should I try and pry it off or is there another screw somewhere that I don`t know about? This is a two handle-one spout faucet.
Removing Oil Seal
[ 9 Answers ]
I have a Murray 18.5HP mower which is leaking oil badly onto the stack pulley. I am "assuming" this is due to a bad oil seal on the PTO side. I have bought the new seal and I am ready to put it on and I am wondering what is the best way to go about it. I have taken the deck off already. Is the... View more questions Search
|