Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Guidelines for drilling a floor joist
[ 29 Answers ]
We need to run some 12/2 Romex through the floor joists of a newly built home. Can we drill the floor joists wherever we see fit, or are there limits?
Floor joist conflicts with lag bolt head
[ 2 Answers ]
I'm building a "mud room" inside our garage. The width is 5' (13' length) and the joists are 2x6 24" o.c. I have ledger on both sides. My issue is that in 2 places I have lag bolts at the edge of the joist, so it gets in the way of the joist and the hanger. Some options seem to be (1)move the...
Shower Floor Drain
[ 1 Answers ]
How do I raise a shower floor drain as we are installing new tile over the old tiles?
Shower drain and floor
[ 1 Answers ]
We are getting our shower floor and drain replaced, and have a problem with the installation. The plumber installed a new drain, but the person who was going to lay the mud floor, said that the drain was not secured. The plumber says that the liner can be cut, the drain secured, and a patch put...
Converting cast iron floor drain to shower drain
[ 3 Answers ]
I am adding a bathroom to my basement, which has partial (complete? ) plumbing already roughed into the floor (in 1976). Sewage lift station (vented) is 3 ft from 4" styrofoam plug (toilet), 4 ft from 1 1/2 inch cast male pipe end extending through floor (lav, have already added vertical vent... View more questions Search
|