Ask Experts Questions for FREE Help !
Ask
    M Vos's Avatar
    M Vos Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 12, 2007, 12:31 PM
    No pressure
    I have two showers. One has incredible water pressure and the other can't be used to wash your hair because you can't get the soap out. Pressure is merely a trickle. It is a new bathroom and I installed a new faucet with the "scald guard" handle. One handle controls heat the other pressure(or lack of it). Would replacing these with regular hot/cold handles solve the problem or is there another solution?
    XenoSapien's Avatar
    XenoSapien Posts: 627, Reputation: 42
    Senior Member
    		  
    #2

    Jul 12, 2007, 03:56 PM
    Check the shower head. Take it off, and see if something is clogging the hole.

    XenoSapien
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bigger pressure tank or increase pressure? [ 5 Answers ]

I bought a new home and the builder had installed a 20 gal pressure tank. I have a jet pump system where the motor sits directly on the tank itself. I really notice the pump running a bit,but also notice the loss of pressure quickly, especially in the shower. Now I was thinking of buying a much...

High pressure at sink, low pressure at shower [ 2 Answers ]

Hello, My sink in the bathroom has good solid water pressure. Next in the circuit is the toilet, which also has good pressure at the angle valve. The shower, however has terrible pressure. I have removed the head, and the pressure out of the shower neck is no better. Shower neck exits the...

House water pressure from well losing pressure [ 2 Answers ]

I have a well at my home that provides the primary water . I have replaced the well pump with a new one, the pressure tank was bad replaced it, pressure switch was bad replaced it. Now I cannot maintain pressure through out my house. The initial pressure is good for about 10 seconds then it slowly...

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...

View more questions Search