Ask Experts Questions for FREE Help !
Ask
    shamimsyed's Avatar
    shamimsyed Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jul 5, 2007, 08:59 AM
    Dodge B250 crank but does not start
    I have a 1992 dodge B250, suddenly stopped on the road, crank but does not start?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jul 5, 2007, 09:22 AM
    . Check all under-dash and under-hood fuses with a test light or multimeter. Here's how:

    https://www.askmehelpdesk.com/cars-t...tml#post252145

    . Ensure battery is fully charged and connections are clean.
    . Test for codes.
    . Test Ignition Control Module (igniter) and coil. AutoZone and O'Reilly Auto Parts will do this for free.
    . Test for spark.
    . Test for fuel.
    shamimsyed's Avatar
    shamimsyed Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Jul 9, 2007, 06:32 AM
    Thanks for reply, I have replaced ECM and also checked ignition coil which is fine but no sparks in plugs. I have checked all fuses, checked fuel pressure, checked timing chain, every things fine, but problem is the same. Engne crank but won't start.
    Let me know what else need to be done
    Thanks,
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Jul 9, 2007, 07:47 AM
    You likely need to test/replace the Ignition Control Module. If problem persists, you may have a bad crank position sensor.
    shamimsyed's Avatar
    shamimsyed Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Jul 17, 2007, 11:01 AM
    Thanks for your help, Finally I have started the Van. The refurbished ignition coil was not good so Then I Install an OEM ignition Coil. But I have another problem which is Odometer. I replaced speed sensor but still odometer won't show speed. I already checked all fuses. I do not know what I am missing.

    Thanks
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Overheating problem in 1992 Dodge B250 van [ 5 Answers ]

I have a van that still has an overheating problem though it has been to the shop. The places that did the repairs replaced one of the heater hoses and the bypass hose which fixed the initial problem of overheating and leaking coolant. The leaking has not occurred since then. However, the...

1992 Honda Accord Crank/No Start [ 5 Answers ]

92 Accord, Cranking but not starting. Fuel pressure is good, No spark. Distributor, Cap, rotor, ignitor and coil all good. Main Relay good. Fuses all good. ECU problem?

95 Mazda 929 won't crank or start [ 10 Answers ]

I have a 95 929. Its been really good to me up until last week. It'd been acting like it had weak juice, not wanting to start right away, especially if I ran the ac before I cut it off. Last Friday I start it in the morning and after a few worrisome secounds it started up. After work, same thing....

94 camry ECM code no.1 crank no start [ 4 Answers ]

Hi, Check report: According to repair manual, checked ECM code, but read diagnosis code is No.1(means normal). Condition: 1.Battery voltage is above 11v.(done, new battery) 2.The throttle is fully closed.(no done. I did not know how to close it) 3.Transaxle is in Neutral.(done) ...

93 Dodge B250 van dies [ 1 Answers ]

My van runs perfectly, then without any rhyme nor reason it will die. When this happens, I pull over, turn off the ignition and then turn it back to run. If the check engine light comes on it will start and run perfectly again, if it does not come on, then I must turn it off again and wait....

View more questions Search