[glaseke]

How to drain water in fuel from 6.0 diesel engine owners manual doesn't give good explanation

[TxGreaseMonkey]

Two simple things need to be done (in this order):
. Purging water from the fuel tank, and
. Changing the fuel filter.

Purging Water from the Fuel Tank

Tools needed:
. 13 mm wrench

Parts needed:
. Small piece of hose

1. There is a small yellow/green lever, left and rear of the black circle cap. Attach hose to the small outlet near the lever and route the other end into a can. Push the yellow/green lever away and to the right to open the valve. Turn key to ON. Watch runoff from the hose and turn key OFF, when diesel fuel starts to run out.
2. Close lever by pushing lever to the right and towards you.
3. Start engine--it is self priming, so it should start quickly or within a few cranks.
4. Fuel tank is now purged of water.

Changing the Fuel Filter

Tools needed:
. Fuel filter wrench or two Vise-Grips
. 13mm combination wrench or deep socket

Parts needed:
. Fuel filter

1. With the 13 mm wrench or socket, remove two plastic coated nuts holding the black cover on the engine. Do this while the engine is cool.
2. Remove black cover.
3. With the filter purged and using the wrench, remove the black cap by turning counter-clockwise. If you do not have a wrench, place one of the Vise-Grips on one of the fins sticking out from the center-ring on the cap. Place the other on the fin directly opposite it. Grab both grips like a large screwdriver and turn counter-clockwise. The cap should come off with a little force.
4. Remove the old filter and o-rings from the tub.
5. Make sure the tub is clean and free of debris.
6. Place new o-ring on the filter and drop new filter in the tub. Generally, it can go in only one-way.
7. Place new gasket on tub-ring and screw cap clockwise. Make sure cap is secure.
8. Replace black cover on engine and tighten nuts. Start engine. It is self-priming, so it should start quickly or within a few cranks.
9. Fuel filter is now changed.