Ask Experts Questions for FREE Help !
Ask
    parti94's Avatar
    parti94 Posts: 5, Reputation: 1
    New Member
     
    #1

    Jun 22, 2007, 08:59 PM
    Should my washer drum spin as it pumps out water?
    I have a Kenmore 80 Series washer, model number 100. 16862503. I noticed that when the water is being pumped out the drum is not spinning. After I open and close the lid when it is pumping out the drum starts spinning. Is this a problem I should be concerned with?

    Mike
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
     
    #2

    Jun 23, 2007, 04:12 AM
    Could be an indication of a bad lid switch. Just had that same issue this week. On some models an imbalance switch will cause this as well. If the load is off balance or too much water is in unit it will interrupt power and once you open lid it resets.Also check the unit is level. Good luck
    pipemaster17's Avatar
    pipemaster17 Posts: 11, Reputation: 3
    New Member
     
    #3

    Jun 23, 2007, 01:42 PM
    Approximatley how old is this machine?
    parti94's Avatar
    parti94 Posts: 5, Reputation: 1
    New Member
     
    #4

    Jun 24, 2007, 08:46 AM
    Quote Originally Posted by pipemaster17
    Approximatley how old is this machine?

    The machine is about 18 months old.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #5

    Jun 24, 2007, 10:07 AM
    The spin cycle does not happen until the drum is nearly empty. The spin is part of the rinse not the drain cycle.
    pipemaster17's Avatar
    pipemaster17 Posts: 11, Reputation: 3
    New Member
     
    #6

    Jun 24, 2007, 11:43 AM
    This unit should pump out first before it spins. If it doesn't it would eventually burn up your clutch . By opening the lid you are activating the spin before it has emptied. This unit stops for a second or two before it spins and you are simulating this when you open the lid. Hope this helps.
    Pipemaster17

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washing machine will not drain. The drum will not spin. [ 1 Answers ]

Washing machine will not drain. The drum will not spin. It make a loud whirring/grinding noise. There is no obvious blockage and have checked the pump. The pump is working fine and the impeller spins. Is this a blockage in the pipe or something else

Kenmore washer still has water after spin cycle [ 1 Answers ]

I have a Kenmore washer 80 series model 110, After the spin cycle finishes there is still some water in the washing machine. We restart the cycle and then all the water is gone. This doesn't always happen, sometimes it works fine. Any ideas would be appreciated

Kenmore washer is leaking water inside the drum and flooding [ 1 Answers ]

Hello, My Kenmore washer (which is about 7 yours old) started to leak water (inside the drum) long after the load has been done. One day it leaked so much that it flooded the entire garage. I have turned off the water and can not use it till I resolve this problem. Please give me some...

Washing machine drum won't spin [ 1 Answers ]

When I switch the washing machine on, it starts to work normally but the drum will not turn yet you can hear the turning and the spinning sounds. I check to clean the drainer and all other links to the drainer and the drum will not spin.


View more questions Search