Ask Experts Questions for FREE Help !
Ask
    robin9's Avatar
    robin9 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 4, 2007, 06:39 AM
    Furnace
    My furnace will not come on and the fuse keeps burning out what could be the problem.
    We do not want to all a repairman if we can fix it ourselves.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    May 4, 2007, 10:25 AM
    If the fuse keeps going bad it means you have a short circuit. If you are capable and have a meter and know how to use it you can trace the wiring down and find the short. If you are not capable of this you need to call for professional help to come to your home and find it for you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Furnace [ 1 Answers ]

Furnace goes through prestart,then ignites, burns for 5 secs goes out but everything keeps running as if it has just started up. This repeats about four or five times till it finally starts.

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search