Ask Experts Questions for FREE Help !
Ask
    james hald's Avatar
    james hald Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 30, 2007, 08:50 PM
    Panel rating - Raintite Class CTL #AL-36422
    Where can I get the rating on an older Raintite Panel. Right now there is a 70-Amp main breaker and I want to upgrade this to 100-amp. The inspector wants something that shows this panel is rated for 100-amp service. Tried a search on the Internet and didn't come up with this panel anywhere. Suggestions?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    May 1, 2007, 02:38 AM
    Really need more info on the panel, such as the manufacturer ,the number given sounds like a UL number, not a part number. It may be, but without a make it is hard to tell you anything about the panel.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Main Circuit Panel to Branch Panel? [ 1 Answers ]

Hello experts, OK... My Main Load center in my home has a branch circuit connected to a 60 amp breaker. The branch feed wire is a 4awg copper wire. The branch panel is downstairs and it has a 100amp main cutoff breaker installed in it. It feeds the whole downstairs including... (1)...

Kenmore Elite Dryer Toe panel - how to get panel OFF! [ 3 Answers ]

I have a Kenmore Elite Model # 110.600094990 27 inch Electric Dryer - NOW How the heck does one take the Toe Panel Off / or Open this lower section of the dryer? There are two lower edge clips and two upper edge retainers. I CAN NOT get the panel to budge! This is a 7 yr old unit. Thx DAS

CTL vs Non-Ctl; Now what can I do [ 3 Answers ]

OK I understand the difference between CTL and Non-CTL. I am becoming confused. I had a licensed electrician give me a quote to install a 100 amp 2 pole breaker into my 40 space panel. But he would have to use tandem breakers in order to get the 2 pole breaker to fit. When I reviewed the panel,...

42 max vs CTL [ 1 Answers ]

OK, getting closer. It sounds like even though I have a cuttler hammer panel which has a max of 10 tandem breaker slots (slotted bar), I can still add a tandem breaker (one that is a non-ctl) to this panel as long as I do not exceed the 42 max pole requirement. If this is the case then I am set...

Electrical outlet rating vs. Circuit breaker amperage rating [ 5 Answers ]

Hello to all, I am new to this forum, please excuse me if this question has been answered. I just bought a Thermal Dynamics Plasma cutter. It has a Nema 50-P plug end on it, which I assume is to be plugged into a Nema 50-R outlet. In looking in my reference book, this is a 3 wire...

View more questions Search