Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing a brass closet flange on a lead pipe
[ 3 Answers ]
Okay, so I'm renovating my bathroom and running into some issues with the old plumbing. Here is a link to some pictures of the situation which will do a much better job at describing things than I can. Picasa Web Albums - Jonathan - plumbing Obviously the ideal situation would be to...
Connecting pvc to pvc with no hub fitting
[ 8 Answers ]
My plumber ran into a dilemma when installing rough plumbing for a new basement bathroom. After already laying the pvc piping in place under the broken up concrete floor we found the pvc to cast iron Tee connections leaking. This was discovered after I had filled the opening with a base of gravel...
How thick is the lead in a lead joint
[ 2 Answers ]
Im getting ready to take the Indiana pluming test and I was wanting to know how thick the lead Is suppose to be in the hub of the cast iron.
Replacing a toilet flange with a lead connection
[ 6 Answers ]
I am about to pull up my old toilet and take a close look at what's underneath. I am also going to go over the original plank sub-floor with fresh 3/8" ply (followed later with thin lauan for eventual linoleum) there is a visible floor patch from an old repair. Given the fact that there has been a...
Replacing lead pipe with pvc
[ 9 Answers ]
The lead pipe and drain from my father-in-laws' bathroom is leaking and needs to be replaced. I'm tempted to just remove all of the lead (only a few feet) and cast iron all the way to the entry into the main discharge. Currently the 2 pieces of cast iron have a leaded seal. How do I connect... View more questions Search
|