Check out some similar questions!
How to mill planks, with hand tools...
[ 6 Answers ]
I have been in need of fixing up my chicken coop. I built it from scraps that where piled up, old doors, old pieces of lumber and plywood, scrap wood. Turned out really good for about a year. It's still really sturdy but bears and wild animals are taking a toll on its outside. I have been...
Working with Brazilian Cherry planks
[ 4 Answers ]
I am in the process of making a table top from 3 1/8" Brazilian Cherry planks that I got from Lumber Liquidators. The same material one would use for hardwoor floors. The table will measure 53" square with a removable center piece which is 16". I have glued the three sections that make up the...
Model Ship Building - How to Bend the Planks Around the Bow
[ 1 Answers ]
How do I bend planks around a model ships rounded type of bow
Problems with laminate flooring/planks peaking
[ 3 Answers ]
We recently had some shaw 8mm laminate flooring installed. Very soon after the install, a few boards starting peaking up on the ends. I thought it was maybe touching a wall, but I read that the planks on both sides would push up against each other. We had the installer out and he says it's the...
Laminate Flooring Planks Not Flat
[ 3 Answers ]
Hi there I am laying a laminate floor myself. The planks came wrapped and pakaged they are not flat. When taken from the pakaging there is a slight bow/sag in them. Will this affect the laying of the floor? Will it flaten out? Any comments or suggestions would be appriciated. Thanks View more questions Search
Add your answer here.
|