Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Name of old molding toy...
[ 0 Answers ]
Circa late 60's early 70's, the idea of the Mattel thingmaker. The molds as I recall were clear plastic, the "goo" was I believe latex has it had already got hard in the bottle by the late 70's when I had one, no heat was used that I recall Mine the molds were for a soccer player, with ball, the...
What is a t molding?
[ 1 Answers ]
I tiled a concrete floor and it butts up to carpet. The metal transition strip comes with little nails, but the concrete bit is too big and the nails don't fit the hole. I tried gluing the nails in, but it didn't hold. Will a screw hold the metal strip down? Kathy
Crown molding
[ 16 Answers ]
I need help installing crown molding. Is it necessary to use adhesive as well as nails?
Nailing Molding
[ 7 Answers ]
Quick question: when nailing up molding (base and casing), *where* do you like to nail? Thinner edges, thicker edges? Closer to edge of molding? Closer to center of molding? FYI: I'm using MDF, to be painted. Thanks!
Molding and Trim?
[ 2 Answers ]
I purchased white quarter round molding (the plastic mold proof composite) from Home Depot, and need to install it in my kitchen around the base board trim. What's the best application for this install? I was not sure if I should liquid nail it to the painted wood baseboard, or nail it and then... View more questions Search
|