Ask Experts Questions for FREE Help !
Ask
    Taylor1101's Avatar
    Taylor1101 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 19, 2016, 10:51 AM
    Bladder tank keeps losing prssure
    We just had out well cleaned out recently. For a while the water was very discolored but is finally back to normal.
    Just recently we started having the box trip again. I sat and watched the pressure go from 70 down to 40 then back up, the down and it would shut off. The breaker in the house does n[FONT=Calibri][SIZE=3][COLOR=#000000]ot trip but when we flip the breaker it resets the wellpower box and begins to run again. [/COLOR][/SIZE][SIZE=3][COLOR=#000000]Thisis occurring more frequently. Usually when it’s flipped it goes back to normal,however, the last few times it kept shutting off over and over.[/COLOR][/SIZE][SIZE=3][COLOR=#000000] [/COLOR][/SIZE][SIZE=3][COLOR=#000000]Once we flip the switch there is instantwater and pressure.[/COLOR][/SIZE][SIZE=3][COLOR=#000000] [/COLOR][/SIZE][SIZE=3][COLOR=#000000]We know we havewater but I am unsure what needs repaired.[/COLOR][/SIZE][SIZE=3][COLOR=#000000] [/COLOR][/SIZE][SIZE=3][COLOR=#000000]We have had two companies out already to look at it and did state thatour lines outside needed cleaned and opened back up due to the level droppingbut that we have plenty of water.[/COLOR][/SIZE][SIZE=3][COLOR=#000000] [/COLOR][/SIZE][SIZE=3][COLOR=#000000]I dobelieve have a submersible pump. [/COLOR][/SIZE][/FONT]

    [FONT=Times New Roman][SIZE=3][COLOR=#000000][/COLOR][/SIZE][/FONT]
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
     
    #2

    Oct 20, 2016, 07:38 AM
    1. If pressure is falling when water is not being used, then that would likely be a defective check valve. Could also be a leaking well pipe above the check valve, but not likely.

    2. The breaker tripping is another matter. Is this pump in the well or above ground?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Baffles at Well Point Match Galvanized Pressure Tank but don't Match Bladder tank [ 2 Answers ]

I have been looking for answer to air in the lines for a while now. I was sure that the water level had dropped in my artesian well. I thought the pump was too near the surface of the water level. As it turns out, I was totally wrong. The problem was that there was a mismatch between my pressure...

Well pump short cycling and bladder tank losing pressure [ 6 Answers ]

Hi, I have a well pump (not submersible) that pumps water from a shallow well into a 30 gallon Amtrol Well x-Troll bladder tank. Lately I noticed that the pump was coming on too frequently so I emptied the bladder tank of water and checked the air pressure and It was about 10 psi, so I added air...

Pressure/bladder tank losing pressure? [ 11 Answers ]

Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions...

Storage Tank or Bladder Tank? [ 8 Answers ]

We just had a new well put in. The well person installed a 220 gallon storage tank (not bladder) when we turn on our sprinkler system our submersible well pump cuts in every 50seconds. We are using approximately 16 gallons per minute. Should the well person have put in a bladder tank instead of a...


View more questions Search