 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Had leak at base of tub drain extension. Cracked at elbow which then had another straight piece to a 2nd elbow that went into bottom of an old drum trap(circa 1940's) . Drum trap then emptied out top into what appears to be a 1 1/2 or 2 inch pipe. That pipe angles over into main cast iron drain...
Insi of mechanical engineer(india) ime is equvelnt to Regular B Tech mechanical engineering? After ime we can take addmision in M Tech in regular? Its very hard to clear all subject?
The way the 2" rough in went we ended up with a trap of sorts then a pipe to where the tub trap will be. Not completed yet. Just wondering if a tub trap and a trap made with the rough in piping will cause some sort of problem. The rough in trap was made off a 4x4x2 wye. Would that be adequate...
Hi, I have a large crack in a cast iron waste line. The line at that point serves just the kitchen sink and is vented to the roof. The first plumber I called wants to disconnect the P-trap, install a drum trap, drill through the cabinet and floor, and connect to the waste line down below the crack....
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all...
View more questions Search
|
