Ask Experts Questions for FREE Help !
Ask
    cherylridgeway4's Avatar
    cherylridgeway4 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 7, 2016, 01:42 PM
    Need 15th by 16th stops for a multichoice delta model R10000-UNWS
    Need stops for a delta faucet
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #2

    Aug 7, 2016, 05:19 PM
    Not exactly sure what you are asking for - but if you need Angle Stop, you can pick one up in your local home improvement store.

    If it is a specific "stop" that fits only Delta faucet, call Delta. They will send you one



    Hope that helps

    Milo
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Aug 8, 2016, 02:12 PM
    Yeah Cheryl, contact delta at www.deltafaucet.com and they should be able to get those 15/16" shutoffs to you pretty quickly.

    Good luck!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer stops mid-cycle (Model DPVH880GJ0WW ) [ 1 Answers ]

Dryer stops mid-cycle (Model DPVH880GJ0WW ) Dryer runs for about 15min and then stops with the start/stop light flashing. After 20min I can then restart but it will run for less time than when first started up. It does this even on the Air fluff cycle (No heat). I have: Cleaned the...

Could the valve in my delta model 17 lahara shower be causing low water pressure? [ 0 Answers ]

Drained the house to get rid of water hammer and now shower has low water pressure. I checked shower head aeriator but not the problem. Low pressure only in that faucet.

Delta model # 14478 - reversed hot and cold [ 21 Answers ]

Hi. I have installed my delta faucet (one handle).. the scald guard faucet... in the "off" position, the handle is at "3-o'clock".. to turn it on, you rotate it counter-clockwise... in the fully "on" position, the handle is at "12 o'clock"... however, hot comes out first... then cold... so,...

Disassembly of Delta model #2476 to replace diverter [ 3 Answers ]

Private Message: Delta Waterfall kitchen faucet, model 2476 Today, 02:40 AM avdpierre New Member Join Date: Nov 2007 Posts: 2 Delta Waterfall kitchen faucet, model 2476 ------

Disassembly of Delta model #2476 to replace diverter [ 2 Answers ]

I have a Delta waterfall/#2476 and have determined (through Delta) that the diverter needs to be replaced. Problem: I cannot get the spout off. I have the diagrams for removal but the diagram does not indicate how to loosen the spout. It appears to have some time of retaining clip near the base,...

View more questions Search