| 
 
 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
How to support a load bearing wall, need engineer, cement wall
 [ 3 Answers ]
 I want to remove about 6 feet from an interior wall. The rafters run parallel with the wall but the reason I think it's load-bearing is because one of the trusses rests on the middle of the wall with a lateral x across it. I have existing pictures and a drawing of "the existing" and what is... 
What size headers for interior load-bearing walls?
 [ 2 Answers ]
 I would like to cut out a large part of an interior laod-bearing wall that currently separates the kitchen from the dining/living areas. The section of wall I would like to renovate is about seven feet long, and I would expect to frame it with a stud and double jack studs at each side of this... 
Framing interior door in non bearing wall
 [ 1 Answers ]
 Can I toe-nail header into a bearing stud (king) on one side and use jack and king on other to keep door tight to one side of an existing opening that I am making smaller? 
Free spanning a load bearing interior wall
 [ 2 Answers ]
 I need to know what size of lumber to use to free span acrss 16'6". It is an interior wall inside a new shop for a loft 
Installing half wall in load bearing wall
 [ 3 Answers ]
 We are attempting to make our kitchen open concept with our living/dining room by creating either a half wall or putting in a window (what is the correct name for that?) The wall is load bearing. Do we need a permit for that type of reno? What would be a realistic budget to set aside for that... View more questions Search 
 |