Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replaced the whole gas valve assembly, and still no gas to pilot valve.
[ 2 Answers ]
I replaced the whole gas valve assembly. Checked the voltage according to the print. But I still can't get gas from the pilot valve. The model is 394gaz048I50
Gas line shut off valve dryer
[ 1 Answers ]
We just had our clothes dryer replaced and the installer (from Sears) stated that the gas shut off valve for the dryer was located too high. It is located a little above the top of the dryer. That's where the gas line was run for the dryer-it is about four feet off the floor and parallel to the...
Flexi vs. Black iron gas line to water heater gas valve
[ 3 Answers ]
I have seen gas water heater " install kits" that use the yellow flex appliance line for the gas connection to the gas valve on the water heater. My tank was installed when the house was built and has black iron pipe all the way to the union and into the valve on the tank. I have heard some codes...
Water heater- gas line to pressure valve?
[ 4 Answers ]
I'm inspecting a house and found a water heater installation I've never seen before. The pressure relief valve is on top of the water heater, and it has an IN and OUT. The gas line is connected to the IN, and the OUT goes to the water heater manifold.:eek: Can this be right? Normally I see a...
Connection to gas range gas line too large for gas line intake valve
[ 2 Answers ]
Connection to gas range gas line too large for gas line intake valve. How can I step the range back line down a step. Is there some kind of converter I can buy? View more questions Search
|