Ask Experts Questions for FREE Help !
Ask
    rkdavs24's Avatar
    rkdavs24 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 5, 2015, 01:28 PM
    Gas Line/Valve
    I recently discovered that I don't have the newer (red handle) emergency gas shutoff valves installed behind my gas dryer or gas stove. I had them installed but have a question regarding the old style valve that is still attached along the gas line. (see attached picture for reference).

    I've heard two sides from numerous people regarding the old style valve. That once they open they always tend to leak a little bit. If you have the new red valve installed you should take the old one out and add a coupling in, in its place. Others have said this is not necessary and they do not leak.

    Since I don't intend on shutting the old valves on or off is it necessary to remove them?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Aug 5, 2015, 01:36 PM
    That once they open they always tend to leak
    Never heard that.

    Others have said this is not necessary and they do not leak
    .
    I would agree.

    Since I don't intend on shutting the old valves on or off is it necessary to remove them?
    Not in my opinion.
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
     
    #3

    Aug 5, 2015, 03:29 PM
    I agree with Hkstroud (Harold) as long it doesn't leak wouldn't worry about it, Thanks.

    John
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replaced the whole gas valve assembly, and still no gas to pilot valve. [ 2 Answers ]

I replaced the whole gas valve assembly. Checked the voltage according to the print. But I still can't get gas from the pilot valve. The model is 394gaz048I50

Gas line shut off valve dryer [ 1 Answers ]

We just had our clothes dryer replaced and the installer (from Sears) stated that the gas shut off valve for the dryer was located too high. It is located a little above the top of the dryer. That's where the gas line was run for the dryer-it is about four feet off the floor and parallel to the...

Flexi vs. Black iron gas line to water heater gas valve [ 3 Answers ]

I have seen gas water heater " install kits" that use the yellow flex appliance line for the gas connection to the gas valve on the water heater. My tank was installed when the house was built and has black iron pipe all the way to the union and into the valve on the tank. I have heard some codes...

Water heater- gas line to pressure valve? [ 4 Answers ]

I'm inspecting a house and found a water heater installation I've never seen before. The pressure relief valve is on top of the water heater, and it has an IN and OUT. The gas line is connected to the IN, and the OUT goes to the water heater manifold.:eek: Can this be right? Normally I see a...

Connection to gas range gas line too large for gas line intake valve [ 2 Answers ]

Connection to gas range gas line too large for gas line intake valve. How can I step the range back line down a step. Is there some kind of converter I can buy?


View more questions Search