Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
5/8 in. pex vs. 1/2 in. pex installed in cement heated floor
[ 0 Answers ]
What are the advantages of using 5/8 in. pex in floor heated cement over 1/2 in. pex ?
Can I turn to tighten a pex fitting after it is squeezed on
[ 2 Answers ]
I have leak between 1" female metal fitting and threaded inlet to water softener
Is there an Iron Pipe x PEX crimp fitting out there?
[ 5 Answers ]
This is a hydronic heating application question. I am gut-remodeling a 1920's 2-story. I want to save the cast iron radiators. I ran PEX for the heating runs to each radiator but don't want to come through the floor with PEX. So, my question is (since I think there is a risk of corrosion...
Leaky copper joint fitting
[ 5 Answers ]
I am not a plumber, but I soldered a T-tting into a ½" copper pipe, using a propane torch. I used flux (which was 10 years old, does it expire?) but unfortunately, it has a slight leak because apparently not enough solder got into one of the joints. Then I tried to touch up by adding more solder,...
Pex Piping T-Joint
[ 2 Answers ]
I just found one of my t joints appears to have a small leak. I first noticed the leak when I walked down to my unfinished basment and noticed a wet spot on the cement floor. Upon looking up, I noticed a really small moisture build up which would eventually turn to a drip down to the ground. The... View more questions Search
|