Ask Experts Questions for FREE Help !
Ask
    Archie 2015's Avatar
    Archie 2015 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 23, 2015, 05:59 AM
    How do I fit a motion sensor to my bathroom lighting
    Hi,
    I want to fit a stand alone motion sensor in my bathroom ceiling to swich on my
    LED 230 volt downlighters.
    Outside the bathroom there is an existing light switch with a brown wire a blue wire and an earth
    How do I wire in the motion sensor.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Feb 23, 2015, 03:41 PM
    You can buy motion detection switches. They can be set for a specific on time or switched on and off. I will assume you are in Europe. You will need one that functions on 240. Here is another example, internally switched it appears.
    220V IR Infrared Module Sensing Switch Body Sensor Intelligent Light Lamp Motion | eBay
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I want motion sensor switch to motion sensor switch to light. Need wiring diagram. [ 6 Answers ]

I placed led puck lights on each step of my stairway. Want motion detector switches at top and bottom of stairway. Circuit will be 12-2 power to first sensor. 14-3 wire to second sensor. 12-2 wire to lights. Wiring diagram shown in directions do not work. I tested sensors just one to a light and...

Where is the CVT drive pulley speed sensor located in a honda fit 2008 model [ 1 Answers ]

From my OBD2 tool , I diagnosed the Honda Fit and I got the DTC P1885 CVT drive pulley speed sensor malfunction. I need to locate where in the engine is this speed sensor circuit? I cannot locate it Thanks

Motion sensor [ 0 Answers ]

How do you set motion sansor on ext. garage lite lanters

Sensor lighting for outside use [ 2 Answers ]

I am installing outside lights that have sensors on them but they donot seem to work as per the instructions. They have three wires- white, red and black. Could you tell me how to hook them up proberly so the sensers turn the lights on and off as they should??

Motion sensor lighting [ 5 Answers ]

I have a house with three lights on the front of the house. There is one by the front door and two on the front of the garage. All three lights are on one light switch just inside the front door. I want to put a motion sensor light in front. If I put a motion sensor light on the one by the front...

View more questions Search