Ask Experts Questions for FREE Help !
Ask
    Tmoon76's Avatar
    Tmoon76 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 15, 2015, 02:32 PM
    I can't seem to remove my TA-10 Symmons mixing valve
    I removed the set nut from the TA-10 Symmons valve assembly, but the spigot valve won't unscrew more than half a turn. I don't want to snap anything or damage my pipe, but I put a lot of pressure on unscrewing it and it just won't budge more than half a turn.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Feb 15, 2015, 03:22 PM
    See this video.
    https://www.youtube.com/watch?v=HBC_Qhw10aQ

    See these instructions.
    Scowl down to page 6 "Service"
    Note instructions in paragraph 4.
    http://www.symmons.com/~/media/Files...SysZV89ins.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Symmons shower valve [ 1 Answers ]

My problem is the volume control does not work. (s96-1) The square protrusion on the control handle which slips into a black plastic part Does not move the black plastic part. The plastic part is stripped. Can this be replaced and how is it done?

How to remove symmons cap assembly [ 0 Answers ]

Hi I am new to this forum. I have a situation where I am having trouble removing a Symmons Cap Assembly (T-12A) I have tried to spray WD40 on it and still it is not budging. Can someone tell me other ways I can go about it? Thanks

Hot water problem - faulty check valve or mixing valve? [ 8 Answers ]

Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...

How to remove symmons model a control [ 1 Answers ]

I would like to replace my Symmons Model A Faucet Flow control but I cannot remove it. I unscrewed both visible bolts on each side and a smaller bolt hiding under cover. The handle seems to have frozen to whatever it sits on. Please advise how to remove it. Thank you!

Symmons valve replacement [ 0 Answers ]

There are two showers in my house and the one on the second floor produces hot water for about 30 seconds, unless we turn the heat up for about ten minutes and then take a shower. We have been told to replace the symmons valve including the housing unit. We tried just replacing the mixing valve...

View more questions Search