Ask Experts Questions for FREE Help !
Ask
    tracylhughes's Avatar
    tracylhughes Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2015, 03:36 AM
    Bath tap leaking from where the mixer head is attached to the legs (pillars)
    Can you please tell me what washer I need to stop the leak from the nut where the single lever mixer tap is connected to the pillar legs on my hot water side.
    talaniman's Avatar
    talaniman Posts: 54,325, Reputation: 10855
    Expert
    		  
    #2

    Jan 16, 2015, 07:39 AM
    Pictures, or make and model numbers would be very helpful, and do you mean the sink, or tub? Typically they will all involve the cartridge, but a bit more information please.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Jan 16, 2015, 08:42 AM
    Yes, a picture would be nice. Most of the plumbers here are USA and we use different terminology. Few if any speak the Queen's English.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bath/Shower Mixer Tap. [ 0 Answers ]

I have a bath/shower mixer tap which on the temperature tap has a red button which you have to push in to get to the higher temperatures. I turned a tap too much and this button popped out. I still have control over temperature (can actually turn tap further and get hotter water than before now)...

Bath mixer tap [ 2 Answers ]

Finally I have a problem for you guys. http://blog.victorianplumbing.co.uk/Images/8Ultra-Minimalist-Thermostatic-Bath-Shower-Mixer-Tap-Chrome.jpg Same function but different design to this one. Right for temp and left for flow, pull for shower. Even with the temp full HOT the water is...

4 hole bath/shower mixer tap [ 1 Answers ]

Hello Does the spout of a 4 hole tap system have to be in the middle or can the whole unit be centralised.

Bath Mixer tap [ 2 Answers ]

How do I repair a bath mixer tap when the water is running half into the bath & only half is going up to the shower head? The control for the water to go up the shower head is by pressing down a ring on the bath tap just at the bottom of the hose leading to the shower head.

Thermostatic shower ony works when I turn on an off the bath mixer tap? [ 4 Answers ]

I changed a like for like thermostatic shower which is powered by a pump. However when I switch on the new shower the pump does not kick in, unless I turn on and off either the bath or basin taps? Does anyone have any ideas as to what the problem could be?

View more questions Search