Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replaced water heater turned water back on and cold water pressure was very low
[ 1 Answers ]
Replaced water heater when water was turned back on the cold water pressure was very low the hot was fine.
CHALLENGING QUESTION: Low-voltage switch in a high-voltage circuit?
[ 6 Answers ]
A project I'm working on has an air pump and a water pump that run during operation. When the water tank that the water pump draws from becomes empty, a liquid level switch will be used to shut off both pumps. The original plan was to just place the switch in series with the power supply for...
Track lights: low voltage vs line voltage.comsume the same electricity in the end?
[ 11 Answers ]
Hi! I just installed a section of track light in my living room just to see what it would look like and so far I'm not convinced... you see, I had a regular celing lamp with a 75w incandescent bulb and the room was very well lit... now with the track light I find that I need 3 fixtures with halogen...
Water heater voltage
[ 1 Answers ]
My water heater quite woking. It is a double element unit. The top element is receiving 240V however the bottom unit is only receiving 120V. I understand that the top element feeds the bottom element. If the top element is bad would that cause the problem. I am getting no warm water at all.
What voltage does a typical water heater need?
[ 1 Answers ]
220 or 240? I am converting from gas to electric, and am having to have an additional outlet run into the laundry room. Could the water heater run off the dryer plug until I get an electrician to wire another one? View more questions Search
|