Ask Experts Questions for FREE Help !
Ask
    johnlayell's Avatar
    johnlayell Posts: 6, Reputation: 1
    New Member
    		  
    #1

    Jan 10, 2015, 04:29 PM
    Briggs engine rist pin hole repair
    Rist pin hole in Briggs 10hp block has become oblong and will not hold rist pin in counter weight connecting link. Any ideas as how to repair this?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 15, 2015, 07:06 PM
    "counter weight connecting link"? The wrist pin fits through the connecting rod and holds the piston to the rod. You replace the piston and possibly the rod. Not sure if this has a rod bushing or not. Could cost $200 for all parts
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs and stratton small engine repair [ 2 Answers ]

I have a briggs and straton engine that starts then stops . I pump gas in it and it runs but only for a few seconds, 5 -10... until the gas I pumped in it runs out. If I continue to pump gas in it it stays running. What could it be? How do I trouble shoot this problem?

How to repair briggs and stratton lawn engine [ 2 Answers ]

Engine smokes and use a lots oil. I would like to know how to repair this problem?

I have 4 pin hole wounds on top of my penis they are red what is this [ 4 Answers ]

Mp9 pin hole video recorder [ 4 Answers ]

Why don't I get video when I plug it into usb it gos to media player. I have good audio but no video ?

View more questions Search