Ask Experts Questions for FREE Help !
Ask
    retirementbound's Avatar
    retirementbound Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 17, 2014, 07:45 PM
    Ford engine swap in a motor home
    I have a 1976 motor home on an E250 chassis (actually designated E270) with a 300ci inline six and automatic tranny. It's doing fine, but am worried about getting repairs in case of failure of "obsolete" drivetrain on the road. Any suggestions for newer replacement engine and tranny? I don't need or want a bunch of power - about 150hp (from, say a 350ci V8 engine?) would be acceptable, and a newer 4-speed tranny would be a blessing but 3 speed is acceptable. Would be great if could just lift intake engine and tranny out of something and could then just modify the driveshaft . 1976 era vehicles had carbs, not fuel injection.
    cdad's Avatar
    cdad Posts: 12,700, Reputation: 1438
    Internet Research Expert
     
    #2

    Dec 18, 2014, 05:23 AM
    Unless your investing for sentimental reasons then you would be better off replacing the motor home. The type of swap your talking about would cost more then the motor home is worth.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #3

    Dec 18, 2014, 07:37 AM
    I would be inclined to take really good care of what you have an see what happens. I recently did just that with a 1983 school bus, donated to WMU of Texas, with 162,000 hard miles on it. It's now traveling all over Texas, Oklahoma, and Arkansas selling WorldCrafts to keep women out of prostituion, poverty and human trafficking. I went synthetic all around--engine (6 qts. of Pennzoil Platinum 10W-30), transmission (4.5 gallons of Amsoil Torque-Drive), differential (3 gallons of Mobil 1 85W-140), and grease (Mobil 1 Synthetic). I had to replace the electronic ignition system (cap, coil, rotor, ICM, terminal block and capacitor), plugs, wires, and install a rebuilt brake hydro-boost. eBay and AutoZone were my friends for parts on an old B6000 GMC school bus--very few other places carried parts for it. I went over the brakes, changing the fluid with Valvoline brake fluid (2 qts.). You get the picture--good preventive maintenance may get you many more miles from your vehicle.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #4

    Dec 18, 2014, 02:47 PM
    I agree with other posters. That is a strong engine, been around a long time. Probably has a good torque range for what you have. Newer engines would be near impossible to swap without all the computer parts, gas tank, pump etc.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Engine swap [ 0 Answers ]

I have a 2000 ford E150 4.6 W vin. I came across a 2005 E250 4.6 W vin. Can anyone tell me if I can swap motors Or do I need to modify anything. Looking to see if everything Will bolt right up without any complications.

Engine swap [ 10 Answers ]

What is the biggest or fastest engine in can put in a 94 grand marquis 4.6 v8

How to remove a starter motor from a 2003 ford f350 with 6.0 diesel engine [ 1 Answers ]

I have a 2003 F350 6.0 diesel. I cannot get access to the top bolt on the starter motor to remove it for replacement... any suggestions?

V6 to v8 engine swap [ 4 Answers ]

Is it possible to swap an auto v6 engine for a auto v8 engine in a 04 ford mustang

My first engine swap 2zz-ge engine [ 6 Answers ]

Here's the deal. I have been debating for a couple months no about trying my hand at an engine swap in my 2005 toyota corolla xrs. After doing some research I understand that this can become a serious undertaking. My main question is what are some of the most common road blocks that can be...


View more questions Search