Ask Experts Questions for FREE Help !
Ask
    dgeocaris's Avatar
    dgeocaris Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 25, 2014, 04:16 AM
    Where is the pressure switch in Luxaire forced air furnace
    Where is the pressure switch on a Luxaire forced air furnace
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Nov 25, 2014, 01:15 PM
    Follow the tubing from the combustion blower to the switch.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #3

    Nov 25, 2014, 02:45 PM
    Everyone I have seen is mounted to the plenum inside the front. You need to remove the top front.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I want to replace Air Pressure Switch has 3 wires with Air pressure switch has 2 wire [ 7 Answers ]

The air pressure switch in my furnace has 3 connections, and I need to replace it with an upgraded part which has only 2 connections. 2 of the wires have the same color,Rose, while the third wire is red. Any help how to connect?

Pressure in Gas Forced Air Furnace [ 1 Answers ]

I have a high efficiency Rheem gas forced air furnace. Occasionally, after the induction fan runs for a bit, the main blower kicks on, runs for a minute or two blowing cold air, kicks off for a minute, then kicks on again and blows hot air. Whenever this happens, I also hear a clunking noise...

My luxaire furnace pressure switch close open [ 1 Answers ]

What do I do to correct the pressure switch open problem on my furnace

Pressure switch stuck open Luxaire furnace [ 1 Answers ]

I have a luxaire high efficiency furnace made in 1994 that is getting the error code for the pressure switch being stuck open. I took the rubber hose off to make sure it didn't have any holes or was clogged and then used a paperclip to clean out the connection by the fan, but it is still flashing 3...

80% luxaire pressure switch opens after 8 minutes [ 4 Answers ]

Opens for 1 second and resets just as quick and then loses vacuum from .9 to .6 in another 4 minutes and repeats, added new switch and new press hose still doing it, pulled vent pipe and still doing it, stopped main blower in mid-cycle and still trips, vent mtr. Pulling normal amps, possible weak...

View more questions Search